Diy Flogger

This flogger design is straightforward and has fixed falls attached to a lightweight solid handle a rolled design.

Diy flogger. Fold your cords in half and place the o ring at the middle. 22 x 60cm handle bottom. The pcv flogger below is pretty stingy as floggers go.

We start by cutting our cord. I have also finished the ends using an overhand knot you could call it a double overhand i guess since it has two turns. You can make it slightly less so by adding more tails and slightly more so by cutting the ends of the falls at an angle into points.

I used the nozzle then my fingers to speread the glue in a thin layer. Spread glue along the uncut portion of the leather. This single column is very fast to create and apply.

It is not intended to be secure. Note that the falls will all be the same color on a single flogger. These will be folded in half over the steel ring meaning that the actual length needs to be double the final length of the flogger.

It is more intended to help your partner stay in position. 3cm diameter x 36cm leather. This takes a bit if time but the extra time helps the glue get a little tacky.

When making a simple flogger use 3 8 8mm or thicker so that the falls have the necessary weight. This tutorial uses 3 8. Please review the document making a flogger introduction before beginning this project.